FPGA-Based Implementation of Multiple Modes in Near Field Inductive Communication Using Frequency Splitting and MIMO Configuration

Conventional near field inductive wireless power transfer theory shows that systems suffer from splitting frequency behaviors when strong coupling condition exists between the transmitter and the receiver. However, this characteristic has not been explored for communication. Our analysis demonstrates that the splitting behaviour of frequency creates multiple frequencies that support inductive communication in MIMO configuration. As a result, we implement a binary chirp modulation on an FPGA and validate two channel communication using splitting. This paper introduces the use of chirp signals to spread data and excite inductive MIMO systems. The simulation and experiment show that the splitting frequency depends on a quality factor and the flux coupling condition between the data source and receiver. In other words, the degree of mutual coupling defines the splitting mode. This paper proves that multi-channel communication using splitting can be used for data transmission. The results show that data rates of 50 Mbps or 69 Kbps can be achieved for each channel between the transmitters and receivers when the transmitter and receiver operate at the original resonant frequency of 13.56 MHz or 28 KHz, respectively and the distance between them varies from about 1 cm to 10 cm.