Answers are grounded in this paper and cite their sources.
To investigate the differences in soil moisture characteristic curves resulting from varying degrees of petroleum hydrocarbon contamination, we used a centrifuge and pressure membrane apparatus to measure the soil moisture characteristic curves of two soil types contaminated with six different levels of petroleum hydrocarbons. This study also analyzed the differences between the two measurement methods and examined the underlying causes. The results indicated that as the degree of contamination in the silty sand increased, its water-holding capacity decreased For silty soil, when the contaminant concentration was 1%, the soil’s water-holding capacity increased by approximately 0.1–5.8%. This increase was primarily observed in the lower (soil suction, log10(cm H2O) < 2) and higher suction ranges (soil water suction, log10(cm H2O)> 3.5). As the soil suction increased, the difference between the centrifuge method and pressure membrane instrument measurements followed a pattern of first increasing, then decreasing, and finally increasing again. In the high-suction range, the results obtained using centrifugation were high, whereas in the low-suction range, they were low. Soil texture and the degree of contamination were the primary factors affecting the differences between the two methods. For soil samples with high sand content and low contamination, significant volume compression during the testing process led to large discrepancies in the results, whereas for heavily contaminated soil samples with high silt and clay content, the test results were more reliable, providing a reference for assessing soil water-holding capacity and conducting remediation efforts in various scenarios.
No takes yet. Share an insight, caveat, or question.
CHEN et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: