Answers are grounded in this paper and cite their sources.
Evaluates thermomechanical processing effects on tribological and corrosion performance in niobium-stabilized stainless steel, suggesting significant improvements.
This study investigates the influence of thermomechanical processing on the microstructural evolution, mechanical and tribological performances, and corrosion behaviors of niobium (Nb)‐stabilized 5A duplex stainless steel (DSS). The alloy, containing 0.47 wt% Nb and 0.22 wt% N was fabricated through vacuum induction melting and subjected to three processing conditions, namely, as‐cast, hot rolled at 1100°C with 40% reduction (HR‐1100‐40), and cold rolled with 70% reduction (CR‐70). Microstructural analysis revealed equiaxed ferrite–austenite grains in the as‐cast, while hot rolling promoted dynamic recrystallization, refining the average grain size to ∼26 µm. Severe cold rolling resulted in an ultrafine lamellar structure with an average thickness of 3 ± 0.5 µm, along with 8% ± 1% strain‐induced α′‐martensite. XRD results reveal a marked decrease in crystallite size and a significant rise in microstrain after cold rolling. These microstructural refinements led to substantial mechanical strengthening, with yield strength reaching 1400 MPa and hardness increasing to 412 HV. The CR‐70 condition also exhibited superior tribological behavior, with reduced friction and wear, enhanced erosion resistance, and improved corrosion behavior. Overall, severe cold rolling proved to be the most effective processing route for achieving multifunctional properties in Nb‐stabilized 5A DSS.
No takes yet. Share an insight, caveat, or question.
V et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: