Answers are grounded in this paper and cite their sources.
Develops new aluminium alloys with enhanced mechanical properties for high-pressure die casting, suggesting significant improvements in performance.
The primary aim of this study is to develop new multicomponent aluminium alloys based on the Al–Mg–Si system for high-pressure die casting (HPDC), with superior mechanical and thermal properties compared to conventional alloys, specifically designed to withstand high-temperature in-service conditions. For this purpose, six new multicomponent aluminium alloys were designed and produced by varying the alloying additions of Cu, Zn, Ca, and TiB. Thermodynamic modelling using FactSage was applied to predict the precipitation phase formation and guide the alloy composition selection. The resulting alloys were characterized by X-ray diffraction (XRD), optical microscopy (OM), and scanning electron microscopy (SEM + EDS). Physical properties, including density, electrical and thermal conductivity, were evaluated together with mechanical behaviour under tensile (at room temperature (RT) and at 200 °C) and compressive loading. The results revealed that the developed alloys within the Al-Mg-Si-Cu and Al-Mg-Si-Cu-Zn systems exhibited a balanced performance, combining high strength, hardness, and thermal stability. The presence of the S-Al₂CuMg(Zn) phase contributed significantly to the improvement in hardness and high-temperature strength. Compared to the commercial alloy AlSi9Cu3 HPDC, the developed alloys achieved up to 70% higher hardness, 70% higher yield strength (YS), 20% higher ultimate tensile strength (UTS), and 15% higher elongation (E) at RT. At 200 °C, improvements of 60% in YS and 50% in UTS were obtained, while maintaining elongation values. Under compressive loading, the developed alloys exhibited overall increases of up to 147% in YS and 150% in ultimate compressive strength (UCS) compared to AlSi9Cu3. Among the studied alloys, Al80Mg10Si5Cu5 and Al75Mg10Si5Cu5Zn5 alloys demonstrated the most promising combination of mechanical and thermal properties. The best-performing alloy exhibited a hardness of 165 HV3 and an ultimate tensile strength of 316 MPa, with only a 13% reduction in strength at 200 °C. Under compressive loading, it exhibited a YS of 279 MPa and an UCS of 646 MPa, confirming its suitability for high-temperature structural applications.
No takes yet. Share an insight, caveat, or question.
Villanueva et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: