Answers are grounded in this paper and cite their sources.
Evaluates phosphoric acid concentration impact on adsorption properties of activated hydrochars from apple tree pruning, suggesting optimal concentration for wastewater treatment.
Hydrothermal carbonisation (HTC) is an efficient route to convert lignocellulosic residues into carbon-rich materials for environmental applications. This work evaluates the influence of phosphoric acid (H3PO4) concentration (2.5 and 5 M) on the yield, surface properties, and methylene blue (MB) adsorption capacity of activated hydrochars (AHCs) produced from apple tree pruning. HTC was conducted at 200 °C for 24 h followed by activation at 450 °C. The AHC obtained using 2.5 M H3PO4 developed a markedly higher specific surface area (1,343 m²/g) and micropore volume (0.591 cm³/g) compared with the 5 M sample (468 m²/g and 0.346 cm³/g, respectively), while also exhibiting a narrower average pore width (1.76 vs. 2.95 nm). These structural differences translated into significantly enhanced MB adsorption performance, with the 2.5 M material achieving the highest adsorption ratio and removal efficiency under the tested conditions. Ultimate analysis further confirmed stronger deoxygenation and carbon enrichment at 2.5 M (C = 76.7 wt%, O/C = 0.26) relative to 5 M (C = 53.4 wt%, O/C = 0.78). Overall, the results demonstrate that moderate H3PO4 loading optimises microporosity and functionalisation, yielding superior adsorbents for wastewater treatment.
No takes yet. Share an insight, caveat, or question.
Ben-Salah et al. (2026) studied this question.
Synapse has enriched 8 closely related papers on similar clinical questions. Consider them for comparative context: