Answers are grounded in this paper and cite their sources.
Investigates mechanical wear and detection in rigid overhead contact systems, suggesting critical insights for urban rail safety.
The disengagement of contact wires in rigid overhead contact systems (ROCS) is a critical hazard to urban rail transit, potentially causing pantograph–catenary collisions, wire breakage, and large-scale catenary failures. To investigate its mechanical mechanism and detection approach, a three-dimensional solid and flexible multibody coupled model of a rigid pantograph–catenary system was established using finite element analysis and multibody dynamics simulation. The effects of train speed, contact force fluctuation, contact wire stress concentration, and disengagement degree on pantograph–catenary dynamic behavior were analyzed. The results show that the standard deviation of contact force at overlapping spans is significantly higher than that in other sections, indicating that overlapping spans are high-risk regions for disengagement. The peak stress of the contact wire is mainly concentrated at registration points and increases with train speed, which may promote abnormal wear and local deformation of the conductor rail jaw. Field-observed environmental degradation factors, such as tunnel water leakage, corrosion, and conductive grease deterioration, may further weaken the clamping performance of the conductor rail. Hazard simulations show that disengagement at overlapping spans deteriorates current collection quality and aggravates carbon strip wear, especially at the beginning of the subsequent overlapping span. Based on onboard inspection equipment, an engineering detection route integrating area-scan imaging, three-dimensional profile scanning, and line-scan imaging is proposed to support the inspection of severe and minor disengagement defects.
No takes yet. Share an insight, caveat, or question.
Liu et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: