Answers are grounded in this paper and cite their sources.
A modified drinking-water treatment sludge (MDWTS) by pyrolysis was used as the adsorbent for the removal of phosphorus. The influence of pyrolysis temperature, dosage of adsorbent, contact time and pH on the P adsorption capacity were tested. Meanwhile the equilibrium and kinetics of adsorption process by DWTS and MDWTS were also studied. The results showed that the adsorption capacity of DWTS was greatly improved after pyrolyzed. The increase of pyrolysis temperature was benefit for the phosphorus adsorption. The maximum adsorption capacity (25.32 mg/g) of MDWTS was appeared at 800°C. The adsorption capacity of DWTS and MDWTS was strongly dependent on solution pH especially at low pH. The maximum phosphorus adsorption capacity were achieved at pH 5. As the dosage of DWTS and MDWTS increased from 0.5 to 3 g/100 ml, P adsorption capacity decreased from 7.47 mg/g to 1.74 mg/g and 22.45 mg/g to 3.26 mg/g respectively. High-adsorbent dosage could effectively reduce the unsaturation of the ion-exchange sites of DWTS and MDWTS which caused comparatively lesser ion exchange. The adsorption isotherms of P removal by DWTS and MDWTS were well described by Freundlich models, suggesting the adsorption of phosphorus was a heterogeneous surface adsorption process. Meanwhile kinetics studies showed that the adsorption process of P followed pseudo-second order kinetic model.
No takes yet. Share an insight, caveat, or question.
Qin et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: