Answers are grounded in this paper and cite their sources.
This study investigates the aerodynamic performance of an Audi A4 sedan using computational fluid dynamics (CFD) and machine learning (ML) analysis. The CFD setup was first validated against published DrivAer Notchback wind-tunnel data, showing a C d deviation of 3.25%, and was subsequently applied to the Audi A4-like sedan geometry. The ride height varied from 1.336 to 1.536 m, and the rake angle ranged from 0° to 5° across the four Reynolds numbers ( Re = 4.87 × 10 6 , 9.75 × 10 6 , 14.61 × 10 6 , and 19.48 × 10 6 ). In our ML analysis, gradient boosting emerged as the most accurate predictive model ( R 2 ≈ 0.91 for C d and 0.96 for the lift coefficient, C l ), outperforming random forest and LightGBM. Differential evolution optimization was performed under balanced, drag-focused, and downforce-focused conditions. The Reynolds number had a minimal effect on the optimum location; therefore, detailed results are reported for Re = 9.75 × 10 6 , with other Re values showing similar trends. The baseline geometry (ride height = 1.436 m, rake angle = 0°) had C d = 0.313 and C l = +0.029. Balanced optimization resulted in C d = 0.287 (–8.31%) and C l = –0.083 (corresponding to a net change in Cl of –0.112 relative to the baseline). The minimum drag condition reached C d = 0.285 (–8.95%) with a slight positive lift ( C l = +0.014), whereas the maximum downforce optimization reached C l = –0.108 with a 6.71% drag penalty ( C d = 0.334). Recognizing the resolution limits of the dataset, near-optimal solutions were found within approximate ride-height ranges of ≈ 1.34–1.36 m and rake angles of ≈ 0.1°–4.6°, indicating robust aerodynamic performance rather than singular precise geometrical points. The machine learning predictions were validated against CFD with < 3% error in C d . However, owing to the limited training set of 100 CFD samples, C l predictions exhibited higher validation errors, with the most notable discrepancies occurring in the balanced condition. Finally, under simplified energy estimation assumptions, the minimum-drag configuration indicates an idealized decrease in aerodynamic energy/fuel consumption of approximately 9.1%, whereas the maximum-downforce configuration substantially increases the downforce at the expense of higher drag.
No takes yet. Share an insight, caveat, or question.
Kheirkhah et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: