Answers are grounded in this paper and cite their sources.
According to Bikerman, who attributes failure in adhints to a weak boundary layer, it is almost impossible and meaningless to correlate adhesive strength to surface-chemical properties of adhints. Though his assertion seems to be confirmed by the recent studies of Schonhorn and his coworkers on the methods of CASING and TCR, not a few results have yet been accumulated, which show a close relation between them. In this paper surface-chemical criteria for the optimum adhesion are investigated and the minimum interfacial tension or the maximum wetting pressure is deduced from the published data and our own as a first approximation. It is emphasized that, when critical surface tension γ c would be used as a measure of surface-chemical properties of solid, its variability according to liquid series (nonpolar, polar and hydrogen bonding liquids) should be carefully taken into consideration. The importance is shown for polyethylene and its fluorine substituted polymers, using newly measured contact angle data and Zisman's data. Results of Levine et al. and Schonhorn et al. on adhesive shear strength with epoxy adhesives are replotted against available values of γ c obtained by the use of hydrogen bonding liquid (γ c c ), which are thought to reflect wetting behaviors of epoxy adhesives quite well. Each curve shows a maximum around γ c c = 40 dyne/cm with few points falling off the curves.
No takes yet. Share an insight, caveat, or question.
Kitazaki et al. (1972) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: