Key points are not available for this paper at this time.
Abstract Developing energy harvesting devices is crucial to mitigate the dependence on conventional and rigid batteries in wearable electronics, ensuring their autonomous operation. Nanogenerators offer a cost‐effective solution for enabling continuous operation of wearable electronics. Herein, this study proposes a novel strategy that combines freeze‐casting, freeze‐drying, and printing technologies to fabricate a fully printed triboelectric nanogenerator (TENG) based on polyvinylidene fluorid‐etrifluoroethylene P(VDF‐TrFE) porous aerogel. First, the effects of porosity and poling on the stretchability and energy harvesting capabilities of P(VDF‐TrFE) are investigated, conducting a comprehensive analysis of this porous structure's impact on the mechanical, ferroelectric, and triboelectric properties compared to solid P(VDF‐TrFE) films. The results demonstrate that structural modification of P(VDF‐TrFE) significantly enhances stretchability increasing it from 7.7% (solid) to 66.4% (porous). This modification enhances output voltage by 66% and generated charges by 48% for non‐poled P(VDF‐TrFE) porous aerogel films compared to their non‐poled solid counterparts. Then, a fully printed TENG is demonstrated using stretchable materials, exhibiting a peak power of 62.8 mW m −2 and an average power of 9.9 mW m −2 over 100 tapping cycles at 0.75 Hz. It can illuminate light‐emitting diodes (LEDs) through the harvesting of mechanical energy from human motion. This study provides a significant advance in the development of energy harvesting devices.
Montero et al. (Wed,) studied this question.