Answers are grounded in this paper and cite their sources.
A new technique of the simultaneous excitation of a magnetron sputtering discharge by rf and dc was used for the deposition of undoped ZnO- and Al-doped ZnO (ZnO:Al) films. By this technique, it was possible to change the ion-to-neutral ratio ji/jn on the substrates during the film growth by more than a factor of ten, which was revealed by plasma monitor and Langmuir probe measurements. While for a pure dc discharge the ions impinging onto a floating substrate have energies of about Ei≈17 eV, the rf discharge is characterized by Ar-ion energies of about 35 eV. Furthermore, the ion current density for the rf excitation is higher by a factor of about five, which is caused by the higher plasma density in front of the substrate. This leads to a much higher ion-to-neutral ratio ji/jn on the growing film in the case of the rf discharge, which strongly influences the structural and electrical properties of the ZnO(:Al) films. The rf-grown films exhibit about the three times lower specific resistances (ρ≈6×10−4 Ω cm), due to lower mechanical stress, leading to higher charge carrier concentrations and mobilities. Undoped ZnO films exhibited the largest compressive stress values up to 2.8 GPa. The aluminium-doped films have a better (001) texture and larger grains (dg≈38 nm), which can be attributed to the beneficial role of Al as a surfactant. The better crystalline film quality of the ZnO:Al films is the reason for the much lower compressive stress of <0.5 GPa in these layers.
No takes yet. Share an insight, caveat, or question.
Cebulla et al. (1998) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: