Answers are grounded in this paper and cite their sources.
In order to perform a fine machining of diamond by the ion sputter-machining, it is necessary to investigate various machining characteristics like a sputtering yield, damage and topography of the machined surface of diamond and to develope a prediction method of a geometrical shape of machined work. Therefore, studies on the above mentioned themes have been experimentally and theoretically performed. The obtained results are shown as follows: (1) The layers of sputter machined surfaces of raw and lap-finished diamonds are somewhat disordered in lattice structure, but a thickness of the disordered layer of diamond is thinner than that of silicon single crystal. (2) The smoothly finished surface of diamond is obtained usually by the ion sputter-machining. (3) The sputtering yield of diamond largely depends upon the incident angle of ion and is proportional to the ion energy under the working condition of the ion energy ranging from 0. 5 keV to 1. 6 keV. Moreover, near the incident angle of 50° changes in the sputtering yield and machining rate of diamond seem to be larger than that of the other diamond like lattice such as silicon. (4) The ion sputter-machining is applicable to the sharpening of a stylus such as Talystep's one, an abraded indentor such as micro-Vickers, etc. Moreover, the gene rated machined shape can be predicted by the simple prediction method newly developed.
No takes yet. Share an insight, caveat, or question.
Miyamoto et al. (1980) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: