This is the authors' abstract. We don't add key points for this paper.
t RELATIONS BETWEEN STRESSES AND STRAINS FOR an annealed and presumably isotropic metal can be expressed as a universal function that is independent both of the direction of the test specimen and the state of stress (within certain limits). On the contrary, the stress-strain curve of metal, cold-worked by even a small amount, has been found to vary considerably in subsequent testing, depending upon the differences between either the directions or the states of stress in cold-working and testing, respectively. The variations in the stress-strain curves are apparent primarily in the range of small plastic strains, up to approximately 2 per cent, as illustrated by Figs. 1 and 2 for 24ST and 24SRT aluminum-alloy sheet. The dependence of the stress-strain curve of a coldworked metal upon the direction of testing has apparently not yet been systematically investigated. An indication of this effect is contained in an ANC Bulletin. According to Table 1-1 of this bulletin, sheets in the commercial aluminum alloys 24ST and 24SRT possess practically equal tensile strengths in the longitudinal and transverse directions. However, their yield strength (0.2 per cent) in tension is specified approximately 15 per cent lower in the transverse than in the longitudinal (rolling) direction, this fact being obviously based on the average of a large number of tests. The above-mentioned table shows, furthermore, that the yield strength in compression of the sheet metals is approximately 12 per cent larger in the transverse than in the longitudinal direction.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Klingler et al. (1948) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: