Answers are grounded in this paper and cite their sources.
60 - nm -thick Cr-doped SrZrO3 thin films with polycrystalline structure were fabricated on SrRuO3∕SrTiO3 (100) substrates at 450°C by off-axis radio-frequency sputtering. From room temperature current-voltage measurements of Pt∕Cr-doped SrZrO3∕SrRuO3 structures, reproducible bistable resistive switching behavior was observed. The dominant conduction mechanisms of the high-resistance state were Ohmic conduction in the low-electric-field region and Frenkel-Poole emission in the high-electric-field region, while the low-resistance state fully followed Ohmic conduction. These bulk-limited conduction mechanisms imply that resistive switching phenomena may be related to the conducting path in the SrZrO3:Cr film matrix. In addition, the initial-resistance value of as-deposited SrZrO3:Cr films was much higher than that of the high-resistance state, indicating that the first soft-breakdown behavior (defined as the resistance change from the initial-resistance state of as-deposited film to the low-resistance state) is the forming process which generates the conducting path in the SrZrO3:Cr film matrix. As the set voltage (=switching voltage from the high- to low-resistance state) was increased, both the low-resistance state current and the reset voltage (=switching voltage from the low- to high-resistance state) increased due to the generation of a stronger or higher-density conducting path. We suggest that the mechanism of resistive switching is related to the formation of the conducting path in the SrZrO3:Cr matrix, and that the on-state current is determined by the set voltage which controls the generation of the conducting path.
No takes yet. Share an insight, caveat, or question.
Park et al. (2006) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: