Answers are grounded in this paper and cite their sources.
Introduction. The question of selecting the optimal diameter of gastrostomic tubes for enteric feeding remains unresolved. The aim of the study is to justify the choice of tube diameter for enteric feeding by studying deposits on the inner wall. Materials and Methods. A model for the introduction of specialized enteric and blender food through a tube at a temperature ranging from 36° to 40 °C has been developed. Polyvinylchloride probes with a length of 110 cm and an outer diameter ranging from 10 to 30 Fr with a step of 2 Fr are used as nutrient tubes. An imitation is performed nourishment 5 times a day for 300 ml for 30 days. After simulation, the probe’s internal clearance will wash 150 ml of water with a temperature of 37 °C, dried. At the beginning and end of the experiment, weighing and measuring the length of the probe was carried out. The results and their discussion. The specialized feed caused a blockage of 10 and 12 Fr probes, which were removed by washing 150 ml of water. There was no significant change in the mass of probes after the enteric feeding, indicating minimal sediments on the inner surface. The blending caused a blockage of probes 10, 12 and 14 Fr in diameter. Probes 10 and 12 Fr in diameter could not be recovered from washing with water. The power deposition on the inner walls of the probes was visually determined. No significant changes in the length of the probes were observed during the experiment. However, the change in the mass of probes after the blender feed is statistically larger than after the specialized one (p<0.001, Mann-Whitney criterion). Conclusion. It is advisable to use gastrostomic tubes with a diameter of 14-18 Fr to feed specialized mixtures. 18-24 Fr diameter tubes should be used when using a blender supply.
No takes yet. Share an insight, caveat, or question.
Gavshchuk et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: