Answers are grounded in this paper and cite their sources.
A simple method for the direct determination of mercury in ethanol fuel samples diluted with water by cold vapor atomic absorption spectrometry (CV-AAS) is proposed. The chemical parameters (concentrations of NaBH 4 and HCl) used for the Hg vapor generation for its measurement by CV-AAS were optimized. The calibration curve showed a linear response over the studied range (1–25 μg L –1 ), with a correlation coefficient of 0.9999 and limits of detection and quantification of 0.05 and 0.17 μg L –1, respectively. The relative standard deviations were lower than 3.5%. The accuracy of the method was estimated by applying the recovery test, and recovery values obtained were 84 and 106%. A sample throughput of 45 h –1 was achieved. Simplicity and sensitivity are among the advantages offered by the proposed method.
No takes yet. Share an insight, caveat, or question.
Almeida et al. (2012) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: