This is the authors' abstract. We don't add key points for this paper.
Graphene oxide (GO)/Ti-6-Al-4 V composite coatings were prepared on Ti-6Al-4V alloys by using laser cladding technology, and the effects of laser power on microstructure, microhardness, and corrosion resistance in simulated body fluids (SBFs) were studied. The results showed that when GO sheets were added to the coatings, the phase of the coatings was mainly composed of α-Ti, β-Ti, TixCy, TixOy, and Al2O3. The value of a too low or too high laser power selected could adversely affect the cladding quality of the coating. At a laser power of 1600 W, there was no obvious pore in the coating. Besides, the corrosion resistance of the coating in the SBF was the best; specifically, the Icorr was the lowest (0.738 × 10−7 A/cm2) and the impedance of the passive film was the highest (4.463 × 10005 Ω cm2). The density of the coating has a positive effect on the formation of a passive film. When the porosity of the coating was low, the dense passive film formed on the surface of coatings made it difficult to erode the alloy surface in the corrosive medium. In contrast, the corrosion resistance of the composite coating at a laser power of 1200 W was even worse than that of cast Ti-6Al-4V due to its low density.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Gong et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: