Answers are grounded in this paper and cite their sources.
Pervious concrete pavements are gaining popularity for stormwater management. Therefore, there is an impending need for the development of quality control and acceptance specifications. In this study, the necessary initial steps are taken towards this goal. The procedures to conduct fresh and hardened density/porosity (φ) and 28-day compressive strength (f′c) were evaluated. The proper methodology for casting specimens in the field was identified by examining the agreement between the fresh (D) and hardened density (ρ). The effect of cylindrical size, and curing methods as combinations of air and moist curing during the four-week period on f′c was studied. Both cylinder sizes demonstrated comparable values of hardened porosity (φ = 16 percent) and hardened density (D = 2.11 kg/m3), as well as strong linear φ–D correlations (R2 range 0.60–0.90). The values of D agree well with those of the fresh density (two percent or less difference), which confirmed the suitability of the implemented casting and compaction procedure. Small cylinders presented higher 28-day f′c than large cylinders by 7.7 to 19 percent, depending on the curing category. The two-week air followed by two-week moist curing (2A2 M) method yielded the highest 28-day f′c for both specimen sizes, however, longer periods of moist curing did not result in higher strengths. Cylinders from 1A3M, which were exposed to the longest moist curing, demonstrate the lowest f′c. Thermogravimetric analysis (TGA) confirmed the trends seen in 28-day f′c and proved (that) longer moist curing resulted in the loss of C–S–H and Ca(OH)2.
No takes yet. Share an insight, caveat, or question.
Rangelov et al. (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: