Answers are grounded in this paper and cite their sources.
This paper studies the energy harvesting characteristics of piezoelectric laminates consisting of barium titanate (BaTiO 3 ) and copper (Cu) from room temperature to cryogenic/high temperatures both experimentally and numerically. First, the output voltages of the piezoelectric BaTiO 3 /Cu laminates were measured from room temperature to a cryogenic temperature (77 K). The output power was evaluated for various values of load resistance. The results showed that the maximum output power density is approximately 2240 nW cm −3 . The output voltages of the BaTiO 3 /Cu laminates were also measured from room temperature to a higher temperature (333 K). To discuss the output voltages of the BaTiO 3 /Cu laminates due to temperature changes, phase field and finite element simulations were combined. A phase field model for grain growth was used to generate grain structures. The phase field model was then employed for BaTiO 3 polycrystals, coupled with the time-dependent Ginzburg–Landau theory and the oxygen vacancies diffusion, to calculate the temperature-dependent piezoelectric coefficient and permittivity. Using these properties, the output voltages of the BaTiO 3 /Cu laminates from room temperature to both 77 K and 333 K were analyzed by three dimensional finite element methods, and the results are presented for several grain sizes and oxygen vacancy densities. It was found that electricity in the BaTiO 3 ceramic layer is generated not only through the piezoelectric effect caused by a thermally induced bending stress but also by the temperature dependence of the BaTiO 3 piezoelectric coefficient and permittivity.
No takes yet. Share an insight, caveat, or question.
Narita et al. (2017) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: