Answers are grounded in this paper and cite their sources.
The effect of substrate temperature and post-deposition annealing temperature on the surface morphology, topography and local thermal properties of iron(II) phthalocyanine (FePc) 500 nm thick films was investigated. The investigations were conducted by a combination of scanning probe microscopies (atomic force microscopy, scanning thermal microscopy) and scanning electron microscopy with structural (x-ray diffraction) and chemical (energy-dispersive x-ray spectroscopy) analysis. FePc is always obtained in its α-form. While for heated substrates, FePc crystallites lie flat on the surface, so post-deposition annealing leads to vertically oriented crystallites. The total surface area obtained does not depend significantly on the substrate temperature, while it is strongly dependent on the annealing temperature. For both groups of samples, the increase of roughness was accompanied by a decrease of the sample's thermal resistivity, which is in agreement with the picture of a decreased number of grain boundaries resulting in higher heat transport. The results obtained here show that the exposed surface area of an organic film strongly depends on the thermal treatments; hence surface morphology can be tailored to particular needs.
No takes yet. Share an insight, caveat, or question.
Krzywiecki et al. (2014) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: