This is the authors' abstract. We don't add key points for this paper.
Electrons can enhance SiO2 atomic layer deposition (ALD) at low temperatures using disilane (Si2H6) and either ozone (O3/O2) or water (H2O) as reactants. SiO2 electron-enhanced ALD (EE-ALD) was demonstrated at 35 °C by exposing the sample to sequential electron, oxygen reactant, and Si2H6 exposures. The reaction sequence was electron beam exposure for 3 s, purge for 5 s, O3/O2 or H2O exposure at 0.5–1.0 Torr for 3 s, purge for 10 s, Si2H6 exposure at 100 mTorr for 1 s, and purge for 15 s. The electron exposure was an electron current of ∼150 mA for 3 s. The electrons were produced by a hollow cathode plasma electron source typically operating with a grid bias of ≈−300 V. These electrons could irradiate a sample area of ∼2 × 2 cm2. In situ spectroscopic ellipsometry measurements determined that SiO2 EE-ALD films nucleated rapidly and deposited linearly versus number of EE-ALD cycles. The SiO2 EE-ALD growth rate was 0.89 Å/cycle using O3/O2 and 0.88 Å/cycle using H2O. The SiO2 growth rate was also self-limiting at higher electron and Si2H6 exposures. In addition, SiO2 EE-ALD films were grown by changing the reaction sequence or codosing the electrons with the oxygen reactant. The SiO2 EE-ALD films could be grown on conducting silicon wafers or insulating SiO2 films. SiO2 EE-ALD is believed to be possible on insulating SiO2 films because the secondary electron yield for SiO2 at electron energies of ∼100–300 eV is greater than unity. Under these conditions, the SiO2 film charges positive during electron exposure and then pulls back secondary electrons to maintain charge neutrality. The SiO2 EE-ALD films had properties that were comparable with thermal SiO2 oxides. The refractive indices of the SiO2 EE-ALD films were similar at n = 1.44 ± 0.02 for various process conditions and equivalent to the refractive index of a wet thermal SiO2 oxide film. In addition, all the SiO2 EE-ALD films yielded etch rates in dilute buffered oxide etch solution that were only slightly higher than the etch rate of a thermal SiO2 oxide film. SiO2 EE-ALD should be useful to deposit high-quality SiO2 films for various applications at low temperatures.
Answers are grounded in this paper and cite their sources.
No takes yet. Share an insight, caveat, or question.
Gertsch et al. (2023) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: