Answers are grounded in this paper and cite their sources.
The residual strain of polycrystalline silicon (poly-Si) film is evaluated using the strain-sensitive nature of the resonant frequency of a doubly-supported beam. By introducing the length dependence curve of the resonant frequency, the effect of the residual strain is discussed. Both measurements and finite-element calculations are performed to accurately determine the residual strain in two types of phosphorus-doped poly-Si films. From the finite-element calculations including nonlinear buckling, the post-buckling frequency is more sensitive to compressive residual strain than the frequency before buckling. By also considering these post-buckling frequencies, a more accurate estimation of the residual strain can be obtained. A test chip consisting of 97 poly-Si beams of different lengths was fabricated for residual-strain evaluation. By fitting the calculations with measured resonant frequencies, the residual strains of the films are determined to be -48±5×10 -6 and -400±100×10 -6 for two types of films. The difference in the residual strain is explained by the heat treatment steps of phosphorus-doped poly-Si films. This method is extremely suitable for monitoring small fluctuations in the film residual strain between different process runs.
No takes yet. Share an insight, caveat, or question.
Ikehara et al. (2000) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: