Answers are grounded in this paper and cite their sources.
A micro-Stirling engine is under development for efficient electrical power generation from thermal sources at the centimeter scale. A vital component for efficient operation is a highly pressurized working fluid on the order of 1 MPa. To evaluate fabrication methods and the structural integrity of micro-Stirling engine components at these pressures, a novel isolated micro pressure vessel was designed with a check valve to allow repeated pressurization. Such a device will enable stress testing at varying pressures and compositions to optimize bond methods and the thin-walled glass housing design necessary for engine operation. In this work, we describe microscale check valves that close at pressures ranging from 47 to 188 kPa. The helium leakage when closed was found to be between 0.006 and 0.03 SCCM in the 50 to 200 kPa range. The flow rate when open was 2 orders of magnitude larger than this. The measured flowrates in the valve were higher than predictions by continuum models and gas rarefaction was found to be the cause for the discrepancy. The valves also closed at pressures approximately half what was predicted through structural stiffness and force balancing, this effect could not be fully explained with rarefied gas models. The details of these observations will be discussed. Ultimately, the best valve design for filling a micro pressure vessel should achieve a 1% pressure loss after 5 minutes post filling. This is well suited for the evaluation of pressure vessel bond strength and wall integrity for future micro-Stirling engine development.
No takes yet. Share an insight, caveat, or question.
Cheng et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: