Answers are grounded in this paper and cite their sources.
Sheets of isotactic polypropylene were prepared to have initially random orientation and were subsequently rolled at temperatures below the crystalline melting point. Their crystal orientation was investigated. The orientation of the c axis (fiber axis) was determined from pole figure data obtained by x‐ray diffraction. It was found that rolling produced orientation of the c axis in two preferred directions in the plane defined by the rolling direction and the normal to the sheet. These two directions made equal angles of inclination with the rolling direction. With increased severity of rolling the component of the orientation vector in the rolling direction increased and the angles between the preferred c axis orientation and the rolling direction decreased. Increasing the temperature reduced the angle of inclination of the preferred c axis orientation. This double c axis orientation was not observed in extruded film. An explanation of the c axis orientation in cold‐rolled polypropylene is offered on the basis of local necking down within the sample during the deformation.
No takes yet. Share an insight, caveat, or question.
Zigmond W. Wilchinsky (1963) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: