Cooling of Turbine Blades With Expanded Exit Holes: Computational Analyses of Leading Edge and Pressure-Side of a Turbine Blade

Turbine blades are cooled by a jet flow from expanded exit holes (EEH) forming a low-temperature film over the blade surface. Subsequent to our report on the suction-side (low-pressure, high-speed region), computational analyses are performed to examine the cooling effectiveness of the flow from EEH located at the leading edge as well as at the pressure-side (high-pressure, low-speed region). Unlike the case of the suction-side, the flow through EEH on the pressure-side is either subsonic or transonic with a weak shock front. The cooling effectiveness, η (defined as the temperature difference between the hot gas and the blade surface as a fraction of that between the hot gas and the cooling jet), is higher than the suction-side along the surface near the exit of EEH. However, its magnitude declines sharply with an increase in the distance from EEH. Significant effects on the magnitude of η are observed and discussed in detail of (1) the coolant mass flow rate (0.001, 0.002, and 0.004 (kg/s)), (2) EEH configurations at the leading edge (vertical EEH at the stagnation point, 50 deg into the leading-edge suction-side, and 50 deg into the leading-edge pressure-side), (3) EEH configurations in the midregion of the pressure-side (90 deg (perpendicular to the mainstream flow), 30 deg EEH tilt toward upstream, and 30 deg tilt toward downstream), and (4) the inclination angle of EEH.