Answers are grounded in this paper and cite their sources.
Following a brief introduction in Section I, the properties of pure He³ and of dilute solutions of He³ in superfluid He⁴ which are relevant to the design and understanding of dilution refrigerators are discussed in Section II. In Section III the basic model for discussing the thermodynamics of the dilution process is developed and applied to both a continuously operating refrigerator and to single-cycle refrigerators using both He³ flow and superfluid He⁴ flow. The relative merits of He³ flow and superleak operated devices are also mentioned. In Section IV the thermodynamical properties of He³ in the dilute phase of the refrigerator are calculated, including the dependence of concentration on temperature and the effective enthalpy function. The heat exchange problem is discussed in Section V, first by introducing new measurements of the Kapitza resistance for saturated dilute solutions and then by relating these to the concept of a He³-phonon resistance in the dilute solutions. Finally specific design estimates are made for the heat exchangers. In Section VI the physics of the He³ circulation problem is discussed. The effects of circulated He⁴ and of viscous heating due to He³ flow are also emphasized. Both the effects of thermal conduction and viscosity limit the low temperature attainable in a He³ flow type of dilution refrigerator. There is a lower limit to 'the temperature attainable as a result of these intrinsic factors which is calculated in Section VII.The general characteristics of the refrigeration device itself are reviewed in Section VIII. Section IX contains a detailed description of two systems built and tested by us. Parts of the apparatus discussed are the still, the heat exchangers, the mixing chamber, the condenser and main impedance, interconnections, and mechanical support. The auxiliary cryogenic and pumping systems are also described. In Section X the operational characteristics of two dilution refrigerators are discussed, both in regard to starting them up and to their steady state operating characteristics. The effect of a heat load, of still power, and of the number of exchangers is given. Comparison with the thermodynamical treatment is made. Under suitable conditions a temperature of 10 m^∘{}K can be maintained continuously and a temperature of 4.5 m^∘{}K for short periods of time.
No takes yet. Share an insight, caveat, or question.
Wheatley et al. (1968) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: