Answers are grounded in this paper and cite their sources.
The initial stages of Al(111) oxidation by oxygen were investigated by using x-ray photoelectron spectroscopy (XPS) and high resolution electron energy loss spectroscopy. It was found that surfaces exhibiting no impurities from the Auger electron spectroscopy and low-energy electron diffraction data may show different characteristic adsorption parameters (sticking coefficient, adsorbate vibrational modes, etc.). These parameters change rather dramatically with extended time of Ar+ bombardment followed by annealing prior to O2 adsorption. It was shown that extensive sputtering, followed by 700 K annealing, was necessary to prepare a surface with reproducible behavior. The integral reactive sticking coefficient, S(T), for the carefully prepared surface was evaluated by measuring the O(1s) XPS peak area for O2 exposures below 50 L. At surface temperatures from 95 to 773 K nonmonotonic behavior of S(T) was observed. A molecular precursor state preceding dissociative adsorption is proposed. It was found that the balance between oxidic and chemisorbed oxygen is strongly temperature dependent and influences the oxygen sticking coefficient on Al(111). A step-like formation of the oxidic phase in the temperature range 473–573 K was found to influence the adsorption kinetics. Oxidation causes the transformation of the O2 adsorption process from an activated into a nonactivated one.
No takes yet. Share an insight, caveat, or question.
Zhukov et al. (1999) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: