Answers are grounded in this paper and cite their sources.
Electrical resistance-strain behaviour of nitrogen doped 3C-SiC thin films was investigated to determine whether they could be used as strain gauges. Using a hot wall vertical low pressure chemical vapour deposition (LPCVD) reactor, these films were deposited on thermally oxidised Si (100) and alumina substrates at 2.5 mbar pressure and 1040°C temperature from methyltrichlorosilane (MTS) precursor. The nitrogen doping gas utilised was ammonia (NH3). Using four-point bending method, the gauge factor (GF) was determined for all thin films (0, 9, 17, and 30 atomic % nitrogen doped). Systematic annealing of films in a vacuum atmosphere was used to determine the TCR of nitrogen doped 3C-SiC (111). Film sheet resistance was evaluated using a four-probe approach, and it was observed to decrease as the temperature rises from 40 to 550°C. The resistivity, average TCR, and strain sensitivity of film doped with 17 atomic % nitrogen concentration were 0.14 cm, -103 ppm/°C, and -9.6, respectively, indicating that it can be employed as a strain gauge material in high temperature applications. However, film doped with 30 atomic % of nitrogen concentration showed an increase in the resistivity, TCR and strain sensitivity.
No takes yet. Share an insight, caveat, or question.
Latha et al. (2022) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: