Answers are grounded in this paper and cite their sources.
Experimental study demonstrates ultra-high-speed atomic force microscopy imaging at over 1300 frames per second on collagen fibers, indicating rapid nanoscale scanning without causing specimen damage.
High-speed atomic force microscopy (AFM) is important for following processes that occur on sub-second timescales for studies both in biology and materials science, and also for the ability to examine large areas of a specimen at high resolution in a practical length of time. Further developments of the previously reported high-speed contact-mode AFM are described. Two instruments are presented: (i) a high-speed flexure stage arrangement capable of imaging at a video rate of 30 fps, and (ii) an ultra-high speed instrument using a combined tuning fork and flexure-stage scanning system capable of ultra-high-speed imaging in excess of 1000 fps. Results of imaging collagen fibres under ambient conditions at rates of up to 1300 frames s −1 are presented. Despite tip–specimen relative velocities of up to 200 mm s −1 , no significant damage to the collagen specimen was observed even after tens of thousands of frames were acquired in the same area of the specimen.
No takes yet. Share an insight, caveat, or question.
Picco et al. (2006) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: