Answers are grounded in this paper and cite their sources.
With the use of the constructed model [1, 2], numerical studies of various methods of biomass heating intensification in a fixed bed were carried to choose a pyrolyzer design. Biomass particles heating in seven pyrolyzer design variants were analyzed. The optimal design of the pyrolyzer was found, which allows achieving the minimum time (50−52 s) for heating the pellets in the fixed bed to the minimum permissible temperature of 656−694 °С, at which almost complete conversion of the tar into gas and carbon residue occurs. The heating rate of the fixed bed is high and equal to 788–801 °С/min which characterizes the process of fast pyrolysis. This design consists of two axisymmetric concentric cylinders with two external sources of heat energy: the outer surface electric heating of the cylinder with a diameter of D = 100 mm and electric heating of the pipe inner surface (or heating by combustion products passing through the inner pipe) with a diameter of d = 50 mm. It was found that the ratio D/d significantly affects the bed heating rate. With a 5 times decrease in the inner pipe diameter, the bed heating rate decreases by 3.5 times and is 229 °C/min, which characterizes the slow pyrolysis. When adding a third source of thermal energy — pyrolysis gas with a temperature of 800 °С, the pellets heating rate at D/d = 2 increases by 24 %. The dependences on time of heat flow and temperature, necessary for regulating the enclosure and inner pipe walls temperatures in the range of 800–850 °С were obtained. Bibl. 31, Fig. 9, Tab. 2.
No takes yet. Share an insight, caveat, or question.
Рохман et al. (2024) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: