Answers are grounded in this paper and cite their sources.
Thermoelectric power measurements on gray tin filaments in the temperature range from 77 to 270^∘{}K are described. Data are presented for pure samples and for n-type and p-type samples having various impurity concentrations. Pure samples are always n type, and exhibit a maximum of approximately -100 {μ}v/^∘{}K in the neighborhood of 100^∘{}K. Other n-type samples have a maximum of about -160 {μ}v/^∘{}K at somewhat higher temperature, and this maximum shifts to higher temperature as the impurity concentration is increased. The p-type samples also exhibit a maximum of the order of 140-160 {μ}v/^∘{}K which occurs in the range 90-100^∘{}K. All p-type samples become n type as the temperature rises, and the crossover point shifts to higher temperature as the impurity concentration increases.The measured thermoelectric power of p-type samples is analyzed into electronic and phonon contributions with the help of Hall and electrical conductivity data. The relatively large phonon contribution shows a temperature dependence similar to that previously reported by others for silicon and germanium. A similar analysis of n-type material indicates a much smaller phonon contribution.Other results of the analysis based on the three types of measurements are as follows: The electron effective mass is approximately equal to the free electron mass and is about twice that for holes. Mobilities of electrons and holes are essentially the same and show the theoretically predicted T^-3/2 temperature dependence over a very limited high temperature range with a stronger dependence at lower temperatures. Only a small percentage of added p-type impurities is effective as acceptors, and the impurity concentration in undoped material is nearer to 10¹⁶ cm^-3 than to the 10¹⁷ cm^-3 which had previously been reported by several investigators.
No takes yet. Share an insight, caveat, or question.
Goland et al. (1956) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: