Plasma treatment at atmospheric pressure using a dielectric barrier discharge was carried out to increase the surface hydrophilicity of wood and wood-based materials. Surface energy determination by contact angle measurement revealed an increase in the polar component of surface energy and in total surface energy following plasma treatment. X-ray photoelectron spectroscopy revealed the generation of polar groups and consequently an increase in O/C ratio. The feasibility of plasma polymerization on wooden substrates at atmospheric pressure to create water-repellent characteristics was also investigated. An atmospheric-pressure plasma jet using hexamethyldisiloxane as precursor and air as process gas was used for thin-layer deposition. Treatment parameters for the layer deposition were investigated, as well as the layer topography and chemical composition. Atomic force microscopy revealed a closed surface layer consisting of silicon, oxygen, carbon and hydrogen that exhibited low water permeability.
No takes yet. Share an insight, caveat, or question.
Avramidis et al. (2009) studied this question.