Answers are grounded in this paper and cite their sources.
W-doped Fe 2 VAl has gained a lot of attention in recent years in the field of thermoelectricity due to consisting of benign, earth-abundant metals and having shown considerable Seebeck-coefficients. In this work, we present thin films (≈1 μm) of Fe 2 V 0.8 W 0.2 Al deposited via direct current magnetron sputtering (DCMS) on single-crystalline Si and Al 2 O 3 at room temperature. While coatings deposited at lower Ar-pressure appeared crystalline and in a fully disordered W-type bcc structure in the as-deposited state, coatings deposited at pressures ≥2 Pa appeared nanocrystalline to amorphous in nature. All films initially displayed low electrical resistivity (≈150-200 μΩ cm) and low Seebeck-coefficients (≈−10 μV/K), but nanocrystalline films saw a substantial increase in both properties upon cooling after exposure to temperatures around 300 °C. Subsequent short-term, low-temperature annealing (6 h, 300 °C) of these films increased their Seebeck-coefficients up to and −110 μV/K around 50 °C for coatings deposited on Al 2 O 3 . However, their general conversion efficiency was held back by a disproportionally higher increase in electrical resistivity, almost fully offsetting the increase in the thermoelectric performance and achieving a Power Factor of ≈4 μW/(m∙K 2 ). Thermal conductivity stayed around 3.5 W/(m∙K), independent of heat treatment.
No takes yet. Share an insight, caveat, or question.
Enzlberger et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: