Answers are grounded in this paper and cite their sources.
1 Prothrombin (coagulation factor II) is the precursor of thrombin, which participates as a serine protease (factor II) in the coagulation cascade. Thrombin is essential in the processes of hemostasis and thrombosis (1)(2)(3). The gene that codes for prothrombin is 21 kb in size and contains 14 exons (4). The gene has been mapped on chromosome 11 at position 11p11-q12 (5). Recently Poort et al. (6) reported a PCR-mediated site-directed mutagenesis method for the detection of the factor II G-20210-A mutation. This single-point mutation (G→A) at position 20210, the last nucleotide of the 3′-UT region [4, 6], has been shown to be associated with an increased risk of deep vein thrombosis. The prevalences for the heterozygous genotype 20210 AG found in the Leiden Thrombophilia Study were 2.3% in healthy control subjects and 6.2% in patients. A homozygous AA genotype was not found (expected prevalence 0.014%) (6). The relative risk for thrombosis being associated with the heterozygous state AG was 2.8 (6). The primers and enzyme were chosen in such a way that only the amplification product of the mutant allele was digested; the PCR product of the wild-type allele was not digested. The reverse primer PR 95–315 (5′-ATA gCA CTg ggA gCA TTg AAg C-3′) (6) contains a single-base mismatch G→A (asterisk), thereby creating a novel HindIII restriction site (A↓AgCTT) in the amplified product of the mutant allele. Because only the amplified product of the mutant allele is cut, no internal control for the digestion of HindIII is available in case of an amplified product of the wild-type allele. This could result in wrong conclusions in cases when digestion activity is decreased or absent, for example by influence of inhibitory factors in the reaction mix, and a false-negative result (wild-type) will be reported. Our aim was to generate an internal positive HindIII digestion control. Because the reverse primer is the mutagenic primer, we designed a new forward primer upstream of the published primer PR 93–787 (6), so that a constitutive HindIII site was included in the amplified product. The software program used was Primer-Designer© for Windows, version 2.0. A control site for HindIII was found at position 26400–405. A new forward primer with best matching properties to PR 95–315 (6) was found at position 26302–321: FAC2fw1: 5′-gCA CAg ACg gCT gTT CTC TT-3′. The location of PR 95–315 (6) was at position 26786–807. The amplification product length before digestion was 506 bp. Digestion with HindIII generates in all cases a constant fragment of 100 bp; the remaining fragment was uncut in wild-type alleles (406 bp) and cut in two fragments (383 23 bp) in mutant-type alleles (Fig. 1 A). (A) Location of described primers and restriction sites in the amplified regions of the gene for coagulation factor II (prothrombin); (B) internal digestion control for HindIII in PCR-based detection of coagulation factor II (prothrombin) point mutation G-20210-A; (C) external digestion control for HindIII in PCR-based detection of coagulation factor II (prothrombin) point mutation G-20210-A Primers PR 95–787 and PR 95–315 were previously published by Poort et al. (6); primer Fac2fw1 is novel to this publication. (A) The HindIII/mutation site will be generated by the mutagenic primer PR 95–315 in case of a mutant-type allele; a wild-type allele will remain uncut at this site by HindIII. Only primer Fac2fw1 coamplifies the constitutive HindIII site, whereas PR 95–787 does not. This constitutive restriction site should be cut in all PCR products (wild-type as well as mutant-type); thus internal control for restriction digestion is obtained. (B) PCR was carried out with primers Fac2fw1 and PR 95–315. Even wild-type samples, where the HindIII/mutation site is not cut, will be digested at the constitutive HindIII site; the PCR product is reduced with the 100-bp control fragment and a 406-bp wild-type band remains. Mutant alleles will also be cut at the HindIII/mutation site, which results in a 383-bp band (the remaining 23-bp band is not detectable on the gel). Lanes M, low ladder molecular mass marker; lane 1, undigested PCR product (506 bp); lane 2, wild-type pattern (406 + 100 bp); lane 3, heterozygous pattern (406 + 383 + 100 bp); lane 4, homozygous pattern (383 + 100 bp); lane 5, water blank. (C) PCR was carried out with primers PR 95–787 and PR 95–315. Primer PR 95–787 does not coamplify the constitutive HindIII site; external HindIII digestion control was performed by addition of 0.5 μg of λ-DNA to the digestion reaction. In each digested sample λ-DNA was cut into specific HindIII fragments. Wild-type samples further showed only the uncut PCR fragment of 345 bp; mutant alleles will also be cut at the HindIII/mutation site, which results in a 322-bp band (the remaining 23-bp band is not detectable on the gel). Lane M, low ladder molecular mass marker; lane 6, undigested PCR product; lanes 1–3 and 5, wild-type pattern; lane 4, heterozygous pattern. DNA isolation: Genomic DNA was isolated with the QIAamp® Blood Kit (Qiagen). A slight modification of the manufacturer’s procedure for whole blood was followed to eliminate the inhibitory effect of hemoglobin on Taq DNA polymerase. Briefly, whole blood was initially frozen to lyse red blood cells, and then 200 μL was centrifuged for 5 min at 400g. The supernatant lysate was removed by aspiration and the leukocyte pellet resuspended in 200 μL of PBS. The procedure was then continued according to the manufacturer’s instructions. PCR conditions: PCR was carried out in a reaction volume of 50 μL, overlaid with 2 drops of mineral oil to prevent evaporation. The reaction mixture consisted of 100–250 ng of template DNA, 50 pmol of each primer FAC2fw1 and PR 95–315 (Pharmacia Biotech), PCR buffer (10 mmol/L Tris-HCl pH 8.3, 50 mmol/L KCl, 0.1 g/L gelatin, 1 g/L Triton X-100, 1.5 mmol/L MgCl2), 200 μmol/L of each dNTP (Pharmacia Biotech), and 1.5 U of Taq polymerase (SuperTaq HC; HT Biotechnology). This mixture was submitted to the following PCR temperature profile: initial denaturation at 95 °C for 2 min, 40 cycles with denaturation at 94 °C for 30 s, annealing at 55 °C for 15 s, extension at 72 °C for 1 min; final extension was at 72 °C for 5 min. The thermal cycler used was a Mastercycler 5330 (Eppendorf-Netheler-Hinz) Each PCR run series included a wild-type and a heterozygous DNA control, and also a water control to exclude contamination. Restriction enzyme digestion: Fifteen microliters of PCR product was digested with 0.5 μL of HindIII (10 U) in 1× NEBuffer-2 (New England Biolabs) in a final volume of 50 μL at 37 °C for 2 h. Electrophoresis: Twenty-five microliters of the HindIII digest was electrophoresed in a 3% agarose gel (Agarose-NA; Pharmacia Biotech) that contained 0.5 mg/L ethidium bromide. Electrophoresis was performed for 3 h at 5V/cm in 0.5× TBE-buffer (1× TBE: 90 mmol/L Tris-borate, 2 mmol/L EDTA, pH 8.0). Control lanes consisted of 5 μL of uncut PCR product and a molecular mass marker (low ladder; BIOzym). Patients: We included 200 patients referred to the Twenteborg Hospital with ultrasound-proven proximal deep vein thrombosis (median 44, range 16–83 years of age) in our study. Proximal vein thrombosis included thrombi involving the popliteal vein or above. For all 200 patients tested for the mutation G-20210-A with the above-mentioned modified PCR method, the constitutive HindIII site was cut by HindIII, generating a 100-bp fragment (Fig. 1A and B) and proving a successful digestion. Eleven patients were found to be heterozygous and one patient was homozygous for the factor II mutation. In this way coamplifying the constitutive restriction site is especially useful to confirm the absence of the factor II mutation. In general in an individual, testing for somatic mutations has to be performed only once. Therefore, reliable results are very important and can be obtained by using reliable controls. A constitutive restriction site is an appropriate control in most restriction digestion-based PCR techniques. When no usable control site for the specific restriction enzyme is available in the near region of the mutation, external digestion control could be performed by addition of 0.5 μg of uncut λ-DNA (Boehringer Mannheim) to the digestion reaction. The λ-DNA will be cut in the specific restriction fragments for the enzyme used (Fig. 1C). For example, primers (as described by Poort et al. (6)) were used that resulted in amplified product without a constitutive HindIII site. Digestion control in case of a wild-type was therefore not possible. The specific HindIII fragments of λ-DNA prove a successful digestion (λ-DNA: undigested = 48.5 kb, HindIII fragments of λ-DNA = 23.1 9.4 6.7 4.4 2.3 2.0 0.56 kb (7)). For adequate resolution of the factor II fragments (345 and 322 bp), electrophoresis was carried out in a 3% agarose gel. In this relatively high gel concentration, resolution of large DNA fragments will be poor (or nil) and only the smaller HindIII fragments of λ-DNA will be separated (the 0.56 kb band will not always be visible because of the low amount of nucleic acid). The 2.3-kb and 2.0-kb HindIII fragments of λ-DNA are clearly visible as two discrete bands in a 3% agarose gel, proving a successful digestion. EMBL data (ID: HSTHB, AC: M17262; M33691).
No takes yet. Share an insight, caveat, or question.
Danneberg et al. (1998) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: