Answers are grounded in this paper and cite their sources.
An Al target has been sputtered in a planar magnetron system using argon and argon–oxygen mixtures at pressures from 0.1 to 2 Pa. The characteristics of both dc and rf discharges have been studied. In the dc case, the current is given by a relation of the form KVn where V is the applied voltage and K and n are pressure-dependent parameters. Values of n up to 9 were obtained at the higher pressures but n decreased at lower pressures. For the rf discharge, the target self-bias voltage, Vsb, at a given power decreased with decreasing pressure and was related to the average rf power by a relationship of the form CVsb/(Vsb−V) where V was approximately 1000 V and C dereased from 900 to 500 W with increasing argon pressure. The deposition rate of Al increased linearly with average dc and rf power and there was good agreement between the values for the same power; the rate was 0.93 μm/min at the maximum power of 2.5 kW. When sufficient oxygen was added, the target surface was oxidized and the deposition rate of Al2O3 was only 5% of the Al rate. This is about half the ration predicted for sputtering yields and can be accounted for by a secondary electron emission coefficient, due to ion bombardment, of between 0.4 and 1.2. This is much higher than the value for Al and accounts for a sharp decrease in Vsb when oxide forms on the target surface. At an average power of 400 W at a pressure of 1 Pa, Vsb is 380 V for the Al case and 190 V for the oxidized target.
No takes yet. Share an insight, caveat, or question.
Maniv et al. (1980) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: