Answers are grounded in this paper and cite their sources.
Development of tin/multi-walled carbon nanotube (SnO 2 /MWCNTs) thin films were prepared by sol-gel method. The synthesis of tin oxide (SnO 2 ) was carried out by dissolving tin (II) chloride (SnCl 3 ) in a solvent of 2-methoxyethanol. Different annealing temperatures of 400 °C, 450 °C, 500 °C, 550 °C and 600 °C were proposed in this study. The changes in the structural properties were analyzed by means of transmission electron microscopy (TEM) and atomic force microscopy (AFM) analysis. AFM results indicated very rough surface area of SnO 2 /MWCNTs thin films where roughness values increased linearly from 1.8 nm to 11 nm by increasing the annealing temperatures from 400 °C to 600 °C. The SnO 2 /MWCNTs-based DSSC exhibited good photovoltaic performance with power conversion efficiency ( η ), photocurrent density ( J sc ), open circuit voltage (V oc ) and fill factor (FF) of 0.62 %, 5.6 mA cm -2 , 0.55 V and 0.65 respectively. The obtained structural and photovoltaic performance analysis was proposed as a suitable benchmark for Sn/MWCNTs based dye-sensitized solar cell (DSSC) application.
No takes yet. Share an insight, caveat, or question.
Mahalingam et al. (2015) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: