Answers are grounded in this paper and cite their sources.
A characterization study was conducted on a novel experimental setup designed to investigate the spread of façade fires. This setup consists of a wall divided into an effusion zone, where methane injection simulates the pyrolysis process, and a large inert zone where the flame propagates. Various flow rates were applied to the effusion module and analyzed through direct visualizations, CH* and OH* chemiluminescence imaging, as well as temperature and heat flux. The results highlight and confirm the well-established influence of fuel injection rates on flame behavior and propagation. This standardized configuration serves as a benchmark for comparisons with more complex scenarios involving different arrangements of effusion and inert zones. Moreover, the data generated in this study provide a valuable basis for evaluating the reliability of fire engineering models and codes. • A new setup has been designed to study configurations that enhance the understanding of façade fires. • An initial experimental campaign was conducted on a configuration with a simulated pyrolysis zone, confirming the well-established impact of fuel injection rates on flame behavior and their effect on the wall. • Mean flame height and boundary heights of the intermittent flame increase with higher mass fluxes due to more fuel introduction and buoyancy effects. • Chemiluminescence imaging reveals peak heat release zones at the transition between simulated pyrolysis zone and inert one, intensifying with higher mass fluxes. • Convective heat transfer dominates over radiative exchanges in this configuration, influenced by the specific fuel and effusion module width.
No takes yet. Share an insight, caveat, or question.
Giorgio et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: