Answers are grounded in this paper and cite their sources.
A copolymer consisting of N-methylpyrrole and phenylene vinylene units, synthesized via a Wittig condensation, can be doped by iodine to give a conductivity of approximately 0.1 S/cm. The doped polymer exhibited reasonable stability in air. Electrochemical studies indicate that this polymer is electroactive and chemically reversible both in oxidation (p-doping) and reduction (n-doping). From cyclic voltammetric studies the onset of the oxidation and reduction peak for this copolymer was found to occur at 3.2 and 1.05 V (vs Li/Li+) respectively, thereby, giving a band gap of 2.15 V. This value is consistent with the optically determined band gap of 2.2 eV. Other copolymer systems were developed by altering the benzene unit of the above mentioned polymer to naphthalene or altering the N-methylpyrrole unit to N-butylpyrrole. Both of these copolymers are dopable by iodine (p-doping) to give conducting complexes. These new copolymers exhibit low oxidation potentials probably attributed to the easily oxidizable N-substituted pyrrole units. It was found that by replacing the N-substituted pyrrole unit with a pyridine unit, the polymers became easier to reduce (n-doping). In addition, easily oxidizable side chains such as the dimethylaminophenyl group were attached to the benzene rings of the poly-phenylene vinylene (PPV) units. The resulting polymers exhibited conductivities in the range of 10−4 to 10−6 S/cm after iodine doping. The above polymers were also found to be doped by AsF 5 giving conductivities similar to or slightly lower than that of the parrent PPV polymer depending on the amount of side chain units attached to PPV.
No takes yet. Share an insight, caveat, or question.
Huang et al. (1990) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: