Answers are grounded in this paper and cite their sources.
The present work aims to investigate the effect of curing kinetics on physico-mechanical properties of an epoxy-based coatings. The hydrogenated bisphenol-A epoxy (DGEHBA) resin was cured using two structurally different hardeners namely cycloaliphatic amine, polyamidoamine individually and also with their combinations. The curing reaction of the epoxy resin with these hardeners was studied using a non-isothermal method to determine their cure behavior using temperature-modulated differential scanning calorimetry (MDSC). Isoconversion kinetics were used to determine the activation energies (Eα) using the Friedman (differential), Cai and Chen (integral) method. The activation energy varied from 62 kJ/mol to 44 kJ/mol in the 5% to 95% conversion range. Using the compensation effect, the Arrhenius pre-exponent (Aα) was determined and the kinetic model f(α) was fitted to the modified Sestak-Berggren model with R2 > 0.99. It was found that there was good agreement between the experimental conversion-time data and the model predicted data with regression coefficient R2 > 0.98 for all the compositions with all the heating rates. The epoxy cured with only cycloaliphatic amine exhibited higher tensile strength but lower adhesion strength whereas polyamidoamine-cured epoxy displays lower tensile strength but higher adhesion strength. A combination 80/20 of polyamide and cycloaliphatic amine offers optimum mechanical properties.
No takes yet. Share an insight, caveat, or question.
Shree et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: