Answers are grounded in this paper and cite their sources.
The mechanical behavior of polycarbonate (PC) coextruded as microlayers with a brittle polymer, either poly(styrene‐co‐acrylonitrile) (SAN) or poly(methyl methacrylate) (PMMA), was examined. Adhesion between layers was measured with the T‐peel method. The much higher interfacial toughness of PC/PMMA microlayers compared to PC/SAN was attributed to partial miscibility. Comparison of the microdeformation behavior of 32‐layer PC/SAN and PC/PMMA microlayers revealed that very good adhesion between PC and PMMA constrained yielding of the PC. This was seen in the tensile stress‐strain curves as a broader stress drop at the yield point and a lower fracture strain. Decreasing the layer thickness by increasing the number of layers enhanced the ductility of both PC/SAN and PC/PMMA microlayers. A PC/PMMA microlayer with 4096 layers and a composition of 80% PC achieved the ballistic performance of polycarbonate.
No takes yet. Share an insight, caveat, or question.
Kerns et al. (1999) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: