Answers are grounded in this paper and cite their sources.
Atomic layer etching (ALE) of Al 2 O 3, HfO 2, and ZrO 2 was accomplished using sequential exposures with hydrogen fluoride (HF) as the fluorination reagent and dimethylaluminum chloride (DMAC, AlCl(CH 3 ) 2 ) as the metal reactant for ligand exchange. DMAC could provide either CH 3 or Cl ligands for the ligand-exchange reaction. The presence of the Cl ligand on DMAC led to efficient HfO 2 and ZrO 2 etching attributed to the formation of stable and volatile chloride species. In situ quartz crystal microbalance (QCM) measurement observed mass changes during Al 2 O 3, HfO 2, and ZrO 2 ALE reactions at 200–300 °C. Al 2 O 3, HfO 2, and ZrO 2 were etched linearly versus number of HF and DMAC sequential exposures. The QCM analysis confirmed that the HF and DMAC reactions were self-limiting versus reactant exposure. The QCM studies observed mass changes per cycle (MCPC) of −12.2 ng/(cm 2 cycle), −94.1 ng/(cm 2 cycle), and −75.6 ng/(cm 2 cycle) for Al 2 O 3, HfO 2, and ZrO 2 ALE, respectively, at 250 °C. These MCPC correspond to Al 2 O 3, HfO 2, and ZrO 2 etch rates of 0.39 Å/cycle, 0.98 Å/cycle, and 1.33 Å/cycle, respectively. In comparison, the AlF 3, HfF 4, and ZrF 4 surface layers were estimated to have thicknesses of 3.0 Å, 3.3 Å, and 4.4 Å on Al 2 O 3, HfO 2, and ZrO 2, respectively. The magnitudes of these fluoride thicknesses have the same ordering as the etch rates for Al 2 O 3, HfO 2, and ZrO 2 ALE, respectively. X-ray reflectivity (XRR) and spectroscopic ellipsometry measurements verified the etch rates for Al 2 O 3 ALE. XRR analysis also confirmed smoothening of the etched Al 2 O 3 film. The etch rates for Al 2 O 3, HfO 2, and ZrO 2 ALE increased with temperature from 200 to 300 °C. A comparison of Al 2 O 3, HfO 2, and ZrO 2 ALE using either HF and DMAC or HF and trimethylaluminum (TMA, Al(CH 3 ) 3 ) revealed that higher etch rates were observed for DMAC for all three materials. Cross-sectional transmission electron microscopy (TEM) studies also revealed that Al 2 O 3 ALE on masked Al 2 O 3 substrates was isotropic and selective in the presence of SiN and SiO 2 . Because of the ability of DMAC to provide either CH 3 or Cl ligands during the ligand-exchange reaction, DMAC should be a very useful metal reactant for the thermal ALE of various materials.
No takes yet. Share an insight, caveat, or question.
Lee et al. (2019) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: