Answers are grounded in this paper and cite their sources.
This work systematically investigates the effect of pre-annealing temperature on the microstructure and properties of ball-milled Fe-Si-Al alloy powders and their soft magnetic composites (SMCs), focusing on evolution of the DO 3 ordered phase and its influence on mechanical and magnetic performances. The results show that the crystal structure evolves as follows: A 2 →A 2 /B 2 →A 2 /B 2 /DO 3 with increasing pre-annealing temperature. In detail, the DO 3 phase becomes evident at around 600 ℃ and peaks at ~21 wt% (900 ℃), and decomposes above 900 ℃. Vickers hardness increases in the range of 500-900 ℃, owing to DO 3 strengthening offsetting the softening effect caused by stress relaxation. Core density shows a rapid increase below 600 ℃ and reaches a plateau between 600 and 900 ℃, followed by a clear decline at higher temperatures. In contrast, the resistivity remains relatively low up to 900 ℃ and increases sharply once structural degradation occurs. Effective permeability reaches its maximum in the range of 800-900 ℃ and exhibits excellent frequency stability. Meanwhile, the total magnetic loss first decreases and then increases with annealing temperature, which can be attributed to the combined effects of stress relaxation, ordered phase transformation, and densification. Overall, a pre-annealing temperature of 900 ℃ yields the most favorable comprehensive performance for Fe-Si-Al SMCs. This work proposes a composition-independent strategy for optimizing the comprehensive performance of Fe-Si-Al SMCs, while shedding light on the intrinsic correlation between DO 3 phase evolution and magnetic/mechanical properties.
No takes yet. Share an insight, caveat, or question.
Lv et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: