Answers are grounded in this paper and cite their sources.
The high-value utilization of plant-mixed hot recycled asphalt mixtures is important for low-carbon road maintenance. However, conventional mix design usually adopts the extracted gradation of reclaimed asphalt pavement (RAP), which cannot accurately represent the effective gradation contribution of RAP under actual hot-mixing conditions. In this study, an AC-20 recycled asphalt mixture with 50% RAP was investigated. The hot-mixing equivalent gradations of different RAP size fractions were measured under various preheating temperatures, and mixtures designed using extracted gradation and hot-mixing gradation were compared in terms of volumetric properties, optimum asphalt content, and pavement performance. The results showed that RAP was not completely dispersed after hot mixing. For fine RAP, the average deviation degree increased from 21.3% at 25 °C to 25.5% at 150 °C, indicating secondary agglomeration. For coarse RAP, the deviation degree decreased from 24.9% in the initial state to 10.8%–11.3% at 110 °C–130 °C, suggesting that appropriate heating promoted particle dispersion. Overall, 110 °C was identified as the preferred preheating temperature. Compared with the extracted-gradation design, the hot-mixing gradation design reduced the optimum asphalt content from 4.43% to 3.95%. At the common total asphalt content of 4.0%, which was used only as a controlled comparison level, the air voids decreased from 5.0% to 2.8%, the voids in mineral aggregate decreased from 13.7% to 12.8%, and the voids filled with asphalt increased from 63% to 78%. At the same comparison point, Marshall stability increased from 10.5 kN to 19.4 kN. Pavement-performance tests were subsequently conducted at the respective optimum asphalt contents of 4.43% for RAP-EG and 3.95% for RAP-HMG. Under these optimum design conditions, the dynamic stability of RAP-HMG was approximately 56% higher than that of RAP-EG, whereas its fracture energy and tensile strength ratio were slightly lower. Overall, RAP hot-mixing equivalent gradation more realistically reflects the actual particle state during mixing and can provide a more reasonable basis for high-RAP recycled asphalt mixture design, although asphalt content, asphalt film thickness, and cracking resistance should be balanced.
No takes yet. Share an insight, caveat, or question.
Zhong et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: