Answers are grounded in this paper and cite their sources.
Integral abutment bridges (IABs) eliminate bearings and joints but intensify soil–structure interaction during earthquakes. EPS geofoam is used as a compressible backfill, though its seismic performance under saturated conditions is not well understood. This study presents a 60 g centrifuge test of a single-span IAB on spread footings in saturated loose sand, comparing conventional backfill with a 1 m EPS inclusion behind each abutment. Six earthquake motions (PGA up to ∼ 0 . 35 g ) were applied, measuring settlements, rotations, accelerations, bending moments, excess pore pressures, and soil deformation. EPS effects were found to be strongly earthquake-intensity dependent. At low shaking levels (PGA < 0 . 1 g ), responses were similar for both configurations. At higher intensities (PGA ≈ 0.25–0.35 g ), EPS significantly reduced excess pore-pressure generation and foundation settlements despite higher recorded base accelerations. Settlements beneath the left and right abutments were reduced by approximately 70% and 40%, respectively, relative to the conventional backfill configuration. In contrast, EPS increased global rocking, with peak bridge rotations during the strongest motion increasing by approximately an order of magnitude (from ∼ 0 . 004 ° to ∼ 0 . 05 ° ). EPS also amplified structural demand: deck accelerations increased by roughly 10%–40%, while cyclic oscillations of abutment and deck bending moments were nearly doubled, whereas soil-surface accelerations remained broadly similar. These findings show that EPS geofoam does not uniformly reduce seismic demand. Its compressibility lowers earth pressures and settlements but shifts more inertial demand to the bridge superstructure, underscoring the need for design approaches that account for demand redistribution.
No takes yet. Share an insight, caveat, or question.
Asia et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: