Answers are grounded in this paper and cite their sources.
With the rapid proliferation of the Internet of Things (IoT), ensuring a stable, efficient energy supply for low-power devices has become increasingly important. Capacitors, especially those made of lead-free ceramic materials, such as barium titanate (BaTiO 3 , BTO), are promising due to their excellent dielectric properties and high energy efficiency. In this study, BTO thick films were fabricated on stainless steel substrates via aerosol deposition (AD), followed by laser processing to provide localized heat treatment. The effects of the laser energy density and processing gap on the mechanical and electrical properties of the films were systematically investigated. Results showed that a laser energy density of 56 J/mm 2 produced the best balance between modified dielectric properties and minimal substrate damage. While the absolute value of dielectric loss increased due to laser-induced defect formation, the apparent relative permittivity increased by approximately threefold; nevertheless, the elevated dielectric loss level showed a more moderate frequency dependence at high frequencies compared to the increase observed in the as-deposited state. X-ray diffraction analysis revealed enhanced crystallinity, a modest increase in grain size, and reduced lattice strain, indicating partial structural recovery and possible reduction of lattice distortion due to the localized thermal treatment. Thus, while further systematic optimization is required to suppress conduction losses, this work serves as an exploratory processing study demonstrating the fundamental feasibility of using laser post-treatment to modify the structural and electrical characteristics of AD-fabricated BTO films for potential future electronic applications.
No takes yet. Share an insight, caveat, or question.
Matsui et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: