Answers are grounded in this paper and cite their sources.
The widely used trimethylaluminum (TMA)/water atomic layer deposition (ALD) chemistry has been shown to improve the electrochemical cycling stability of LiMO 2 materials, including nickel-rich LiNi x Mn y Co 1- x - y O 2 ( x > 0.5). However, there are many process options users must select when choosing to perform ALD, which makes comparison of ALD-on-LiMO 2 papers difficult. This work studies the significance of three ALD process parameters (temperature, number of ALD cycles, and termination step) on the polycrystalline LiNi 0.8 Mn 0.1 Co 0.1 O 2 (NMC811) electrochemical performance using a 2 3 full factorial design. We observe that termination on a half-step (TMA) leads to inferior electrochemical performance. This work also evaluates the role of the TMA/water ALD process on doped NMC811 powder. When fabricated into full cells and assessed for discharge capacity and energy, overall cell resistances at low and high states of delithiation, and pulse power, the ALD-coated sample did not perform significantly better or worse compared to the uncoated, doped NMC811. Our findings suggest that rather than serving as a barrier film from the electrolyte, low cycle counts of TMA/H 2 O ALD fulfill a role similar to that of the dopants added during the NMC synthesis steps.
No takes yet. Share an insight, caveat, or question.
Nguyen et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: