Answers are grounded in this paper and cite their sources.
• CO 2 and furfural used to obtain valuable monomer: dimethyl furan-2,5-dicarboxylate (FDME) • Hypercrosslinked polymer catalyst prepared via mechanochemical polymerization. • Process evaluation using CO 2 derived from simulated bio-based industrial streams. • Synthesis and characterization of a bio-based polyester from CO 2 -derived FDME. A two-steps thermal process is reported for the sustainable synthesis of dimethyl furan-2,5-dicarboxylate (FDME), a valuable monomer in the production of bio-based polyesters. The route uses a bio-derived molecule, furfural (F), and CO 2 as raw materials. A mechanochemically synthesized hyper-crosslinked polymer (HCP) supported copper catalyst, was developed and applied in a sequential oxidation–carboxylation using moderate reaction pressures (P(O 2 ) and P(CO 2 ) of 6 and 10 bars, respectively), followed by acid-catalyzed esterification. The process was optimized using commercial CO 2 , and further tested using simulated bio-based industrial CO 2 streams. Catalyst recyclability was demonstrated over five cycles with no loss in activity and the low E-factor (18.3 with methanol recycling and water removal), highlight the industrial and environmental potential for the FDME synthesis using this new route. Furthermore, the FDME obtained was used directly, without purification, to synthesize a bio-based polyester by reaction with 1,3-propanediol. The resulting polymer showed comparable properties to those obtained from commercial FDME.
No takes yet. Share an insight, caveat, or question.
Rangel-Rangel et al. (2025) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: