Answers are grounded in this paper and cite their sources.
Support structures are essential for many vat photopolymerization (VP) additive manufacturing (AM) processes, but require manual removal, compromise surface quality, and generate non-recyclable plastic waste. Existing approaches to address this, such as volumetric printing or multi-material resin systems, impose constraints on hardware, resin formulations, and part geometry. Here, we introduce a top-down resin 3D printing method in which prefabricated support structures are used for repeated print cycles. A water-soluble resin is applied only at the support tips to form an interface between the supports and the subsequently printed part. After the part is printed on the prefabricated supports, sonication in a water bath dissolves the interface, releasing the part with minimal force while leaving the supports intact for reuse. We characterize how the interface geometry is related to the support pillar diameter and offset distance to accommodate the soluble support interface, with the best set of print parameters yielding artifacts comparable in size to manually separable, monolithic supports. A single set of supports is reused with no observable change in the support function or release behavior across four print cycles. We demonstrate batch production of several dozen miniature parts released simultaneously, a print-in-place chain assembly, and a model dental aligner on contour-matched supports. Continued development of the reusable, dissolvable interface approach could enable fully automated, zero-touch VP production of complex polymer parts in large quantities.
No takes yet. Share an insight, caveat, or question.
Peraire-Bueno et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: