Answers are grounded in this paper and cite their sources.
Experimental evaluation demonstrates reduced crossover distortion in a boost converter prototype, indicating improved power-factor correction efficiency without heavy digital computation.
In critical‐conduction‐mode (CRM) boost power‐factor‐correction (PFC) converters, the negative inductor current required for valley switching (VS) or zero‐voltage switching (ZVS) reduces the net input charge, particularly near the line‐voltage zero crossings, and thereby causes crossover distortion. Existing digital variable‐on‐time (VOT) methods commonly rely on iterative computation or large lookup tables (LUTs), while their accuracy is also affected by resonant‐parameter deviations and signal‐chain delays. This paper proposes an explicit VOT control method with online effective resonant‐parameter updating. A cycle‐by‐cycle charge‐balance model is used to derive an explicit quadratic on‐time expression, eliminating online iterative solving and large multidimensional LUTs. Compared with the iterative reference solution, the maximum relative errors of the explicit expression are 0.77% at 110 Vac and 2.93% at 220 Vac under the evaluated operating conditions. The effective resonant parameter is updated from the measured zero‐current‐detection timing interval and is applied to both the on‐time and digital turn‐on‐delay calculations. The implemented control law accelerator routine requires approximately 2.3 μs. Experimental results obtained from a 160‐W prototype demonstrate reduced crossover distortion and improved input‐current quality compared with conventional constant‐on‐time control. At full load, the measured input‐current THD is 1.1% at 110 Vac and 4.2% at 220 Vac.
No takes yet. Share an insight, caveat, or question.
Li et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: