Answers are grounded in this paper and cite their sources.
To address the problems of limited motion range, cable wear, and reduced reliability caused by conventional power cables during continuous rotation of robotic manipulator joints, this paper proposes a two‐stage constant voltage wireless power transfer system based on a cascaded LCC‐S compensation topology and its design method. The system transfers electrical energy from the transmitter to two receivers through magnetic coupling, enabling simultaneous power supply to multiple joint loads of the manipulator without physical cable connections. The paper elaborates on the system topology and operating principles, establishes an equivalent circuit model based on fundamental harmonic analysis, derives the constant voltage output condition and voltage gain formulas, and theoretically demonstrates that the output voltages of both stages are independent of the load when parasitic parameters are neglected. A simulation model is used to systematically analyze the effects of load variations and compensation inductance variations on output power, voltage, and efficiency, revealing the influence of key parameters on system performance. Based on the theoretical analysis and simulation optimization, a design procedure for the system parameters suitable for manipulator power supply is proposed. Finally, an experimental prototype is built. The experimental results show that the system achieves approximately constant voltage output within the load variation range, with the two outputs being largely decoupled. The output power of each stage reaches 50 W, and the maximum system efficiency reaches 87.1%.
No takes yet. Share an insight, caveat, or question.
Wang et al. (2026) studied this question.
Synapse has enriched 10 related papers. Consider them for comparative context: